Products tagged with Raft

High-impact 8" W x 18" L ABS plastic blade can take the abuse of multiple paddling seasons.
Airplane-grade 1 1/4" aluminum shaft is strong and resilient, for years of worry-free use.

The thwart has loops on the ends, that mated with the loops on the inside of the tubes, forms the secure Batten Attachment Thwart (BAT) system.
We weld the seams on the burly 48 oz./2000 denier material for long-term durability.

The material used to make all NRS Otter Series rafts, NRS River and Kodiak Cataraft tubes and NRS MaverIK kayaks. It is also used as the frame wear patch that runs along the top of NRS Expedition Series rafts.

Made with our rugged 1 5/8" OD 6061-T6 anodized aluminum pipe, with 1/8" wall thickness.
Cross bar lengths are the center-to-center measurements between the frame side rails.

Roomy enough for a wide mouth water-bottle, you and your passengers will appreciate the convenience of these Cup Holders. 

Make sure to check your frame pipe size either LD (1.25in) or XD (1.5in). 

These pads fit on top of the Aluminum Dryboxes, NRS item number 55077.01, or other dry boxes with minimal alteration.
The self-adhesive back sticks securely to most surfaces. Clean the surface with rubbing alcohol or other solvent before applying.

The Rear Casting Platform comes in two sizes. The Large is sized for the rear compartment of rafts taking a frame 60" or wider. The Small fits in boats with a 54" or narrower frame.
The platform is made from our 3/4" high-density polyethylene (HDPE) mate

The unit consists of a swivel base that allows the seat to rotate 360 degrees, and two hot-forged aluminum plates that are bolted to it.

AIRE PVC Raft Floor/Wear/ Patch Material. Sold per foot x 70"

This two-part adhesive gives high initial bond strength and quickly cures to a high-strength, heat-resistant final bond. Patches can be applied when the glue is tacky.