RAFTS AND INFLATABLES

Down River manufactures in-house with Aluminum, making them strong and light-weight. 
Don't be that person poaching stakes.  Get you own Down River Bomber Sand Stake today!

The Down River Sand Stake Umbrella Holder Combo is not only a sand stake, it's also an umbrella holder! 

These can be glued on any PVC or urethane inflatable or other surface.

Great accessory tiedown point for many outdoor uses.
Stainless steel D-ring for long term corrosion-resistant service.

Brass Oarlock Side Mount with Nylon Bushings
Fits 1/2" Oarlock Shaft
Nylon Bushings
Dimensions in Diagram: A- 1/2"  B-3-3/4"

One of the Boston valves is sure to fit the thread pattern of your inflatable, no matter what brand.
The Boston valves have a square base, which is much easier to turn than a round base, especially with wet hands.

The Down River Umbrella Holder is easy so use, just drill and pin your choice of umbrella, and voila! Shade!

The LoPro™ Fitting allows you to easily configure and customize your frame.
Made from hot-forged aluminum alloy for a strength-to-weight ratio that can't be beat, this streamlined, polished piece of hardware is the heart of the NRS frame system.

Intermediate Pulley that attaches to the U-bolt securing the right-hand cross bar at the rear of the frame.
It attaches to both legs of the U-bolt. Rope leaving the pulley goes to the anchor mast. This pulley ONLY works on the newer forged LoPros.

These pads fit on top of the Aluminum Dryboxes, NRS item number 55077.01, or other dry boxes with minimal alteration.
The self-adhesive back sticks securely to most surfaces. Clean the surface with rubbing alcohol or other solvent before applying.

The durable 12" wide, 1/2" HDPE won't absorb water and is perfect for your boating adventures.
The Bench Seat attaches to the frame cross bars with four conduit clamps and carriage bolts.

Strap dry bags, ammo cans, tackle boxes, Pelican cases, anything you can think of, to your Side Rail Racks.
The racks are made with an 8 inch by 3-, 4- or 6-foot piece of 3/4 inch high-density polyethylene (HDPE) plastic. The raised pattern slip-resistan

Rest, relax and catch some rays on the Land-Shark Pool Mattress!

With the perfect amount of cushioning and a built-in pillow, you are going to have a hard time dragging yourself off this floating mattress when it's time to get out of the pool.