RAFTS AND INFLATABLES

Attaches on both sides directly to a seat bar, raised seat bar, or a cross bar using LoPro™ Frame Fittings. The Small fits on frames 54" wide or smaller. The Large fits on frames 60" wide and larger.

Great accessory tie-down point for many outdoor uses.
Stainless steel D-ring for long term corrosion-resistant service.
4.5" diameter patch.

A strip of neoprene covers the nylon, protecting it from UV and abrasions. Colored Pennel Orca® is glued on top to complete the patch. D-Rings are stainless steel, and available with 4.5", 6" or 8" patches. (8" patches are good for replacing D-Rings that

Two layers of the 2" webbing ensure long-term durability. Large gluing surface gives a great bond for lifting heavy loads.

You don't have to know rocket science to row a boat, but it helps to have gear made by a company who does. Cataract shafts are made with the same filament wound glass/carbon/epoxy composite technology used by the aerospace industry.

The NRS Super 2 HP Pump is an efficient and durable double-chambered pump for optimal power with minimal effort. Great for high-pressured inflatables up to 25 psi.

Scotty Float Tube Rod Holder Mount adapts your rod holder to your raft float tubes. Rod holder not included

The tough 1-3/8" aluminum shaft breaks into two easily managable pieces and assembles quickly with a secure button lock.
The 5.5" x 26" UV-resistant plastic blade is reinforced with the aluminum shaft, which runs the full length of the blade.

NRS stocks the Bighorn II in two lengths. 82" and 88" frames are both an excellent fit for most 14' and longer rafts. Includes four 9' NRS straps and eight strap slides for securing your cooler and dry box to the frame.

The 1" thick rubber stopper goes right over the oar shaft, not over the Molded Oar Sleeve. The 1 5/8" inner diameter is a tight fit on the shaft. Use either soap and water or hair spray to lubricate the stopper and shaft to slide it on. As it dries, hair

Valve Cap for the C7 and D7 Leafield valves. Cap only.