Oar Accessories

Use the oarlock socket on your small boat to mount a rod holder or lake troller downrigger
Install or remove in seconds

They are a heavy-duty plastic so they can clamp securely to the shaft without damaging the fiberglass/carbon fiber/epoxy shaft material.

Brass Oarlock Side Mount with Nylon Bushings
Fits 1/2" Oarlock Shaft
Nylon Bushings
Dimensions in Diagram: A- 1/2"  B-3-3/4"

Reduce fatigue and prevent blisters!
Grips fit Carlisle, Cataract and most other oar handles. Installation tip: Use hair spray to lubricate the inside of the grips, then just slide them on! 6" long, 1-1/8" inside diameter.

NRS proprietary manganese bronze alloy has outstanding rebound memory in the horns.
The 3 1/2" long shaft is turned to a 1/2" diameter and is drilled for a split ring fastener (included). They work well with the NRS GigBob Oar Mounts.

The bushings produce a smooth, no-squeak stroke as you row your raft, cataraft or drift boat.
Note: These bushings are only for the newer hot-forged oar mounts.

The NRS proprietary manganese bronze Superston alloy gives you amazing strength and outstanding rebound memory. Built tough for the toughest jobs, they are used by outfitters the world over.

The spline of the Oar Right fits between the horns of an open oarlock to "lock" your oar blade in position for the most effective stroke. You can still feather the oar blade by simply tugging the oar in so the spline of the Oar Right clears the oarlock ho

If you are not using oar rights, plastic stoppers will position and keep your oars where you want them to be. Use large stoppers with Molded Oar Sleeves.

The 1" thick rubber stopper goes right over the oar shaft, not over the Molded Oar Sleeve. The 1 5/8" inner diameter is a tight fit on the shaft. Use either soap and water or hair spray to lubricate the stopper and shaft to slide it on. As it dries, hair

An unexpected loss of an oar can ruin your whole day. The Oar Tether gives you a fighting chance to get that oar back in place in time to avert disaster. There's a stainless steel ring on one end and a webbing loop on the other end of the Tether.