RAFTS AND INFLATABLES

The Rear Casting Platform comes in two sizes. The Large is sized for the rear compartment of rafts taking a frame 60" or wider. The Small fits in boats with a 54" or narrower frame.
The platform is made from our 3/4" high-density polyethylene (HDPE) mate

Easily removes ugly dirt, stains and frame marks.

Stainless steel D-ring for long term corrosion-resistant service. Attach using Clifton Urethane Adhesive or Stabond Adhesive. 6" diameter patch

The spline of the Oar Right fits between the horns of an open oarlock to "lock" your oar blade in position for the most effective stroke. You can still feather the oar blade by simply tugging the oar in so the spline of the Oar Right clears the oarlock ho

Whether you're pushing big water or fishing bony streams, the NRS Helix Blade's asymmetrical shape delivers efficient strokes with a curved tip to avoid bouncing off rocks in shallow waters.

If you are not using oar rights, plastic stoppers will position and keep your oars where you want them to be. Use large stoppers with Molded Oar Sleeves.

The 1" thick rubber stopper goes right over the oar shaft, not over the Molded Oar Sleeve. The 1 5/8" inner diameter is a tight fit on the shaft. Use either soap and water or hair spray to lubricate the stopper and shaft to slide it on. As it dries, hair

Large, high contrast display reads from 0 - 20 psi and is easy to read in all conditions. This gauge must be in the valve while you read the gauge.

With its diminishing tube design, the Tributary 13 HD Self-Bailing Raft punches through waves and opens up more bow and stern cargo room.

Whether you're manning it with a paddle crew or rowing it, this boat is good for adventure adrenaline or family fu

The NRS Front Thigh Hook lets you fish with confidence even when the water, or your oarsman, is less than smooth. Hook either, or both, legs inside for excellent balance while casting.

Valve wrench specifically for Leafield B7 Inflate/Deflate Valves and Leafield A6 Pressure Relief Valves.

Made with NRS's rugged 1 5/8" OD 6061-T6 anodized aluminum pipe, with 1/8" wall thickness.
Cross bar lengths are the center-to-center measurements between the frame side rails.